Home > Computer Freezes > Computer Freezes And Too Many IEEE 1394 Bus Host Controllers

Computer Freezes And Too Many IEEE 1394 Bus Host Controllers

However, if you go back to 8.03 the problem stops. i had pro tools running on this comp since the 8 0 2 release. When the load is 100%, sometimes I get again down when I move the window and sometimes I have to do a hard reset...I have written now a "tool" what changes When the test finishes, Vista/Win7 will boot automatically and will display a notification balloon with the results of the test. Source

Lenovo Thinkpad T60p, C2D 7200, 4 GB quality Ram, TI controller chip in the Thinkpad, TI chip FireWire PCMCIA card, Win 7 Pro 32 bit. Once there, open Properties and select “Install New Driver” in the driver tab. Since Vista/Win7 outsources visual processing to your video card, it will not take up any additional resources. Though, all this didn't happen when using the computer normally, but rather when booting and starting up Gnome.

Windows Update finds and installs a driver. For now, you're only stopping them, not disabling them. Performance These adjustments are some of the more sweeping optimizations in this guide.

Before doing so, it is highly recommended that you reenable everything in the Security center, and also connect immediately to Windows Update for the latest security updates from Microsoft. You can choose a partition that you want to image. Nov 28, 2012 8:13 PM Helpful (0) Reply options Link to this post by 2called-chaos, 2called-chaos Dec 13, 2012 2:52 AM in response to hwamil Level 1 (0 points) Dec 13, With audio applications, this is not a good idea because they are very demanding on system resources, so using a lower-speed hard drive is not a viable solution.

It is so easy for Digitechsupt to just upload his/her Sandra report. Maybe you could purge your computer of a bunch of those apps and see what happens, like the anti-virus, all the updates, network/internet stuff... Try finding one elsewhere and it should clear up the problem.But then it has been my experience that FW on the Mac OS X side is just as flaky with constant visit An entire drive full of sessions can be lost at any time due to a hard-drive crash.

Thanks -- and my apologies for the mistake. Think of this as a regularly scheduled oil change. That's what I have on my laptop! Answer: The firewire port on the camcorder could be shot.

Their computer did not recognize the camcorder either. https://discussions.apple.com/thread/4175086?start=0&tstart=0 i'll run a sandra now. Anyway, use the uninstaller on your PT8 disk and dump 8.0.4 and install to 8.0.3 and get back to work. In the Device Manager, you can right-click on any device and choose "Disable." This will essentially turn that device off, releasing its drivers and stopping any resources from being used to

i want to churn out every possibility to solve this problem http://lispmachine.wordpress.com Offline #11 2007-06-26 11:52:45 uwolfer Member Registered: 2006-02-27 Posts: 46 Re: X freezes (UNSOLVED) My lspci output, using the this contact form I will give them a look over and look for anything odd or whatnot. Even though PreSonus Studio One is much easier to use than most DAWs, it’s still a deep program. Walk through the procedure step by step as you read it.

Hopefully part of the parts list will also include the exact driver number used for all components on these systems. i plan on making a asus build. I rolled back to 100.14.09 and they appear to have stopped.I will also say that I am experiencing the other X freezing that people are complaining about. have a peek here The Seagate drives that ran well with 8.0.1 were a poor choice for 8.0.3 and threw errors, the WDC Black drives now run perfectly.

My system is rock solid until 8.04.. Then, you can go through your processes, one by one, to see what needs to remain enabled. Slower drives may not be able to keep up with the demands of recording and streaming audio.

Find Solutions, ask questions, and share advice with other HP product owners.

Even messier than what you described with your 002. These steps will allow you to work efficiently without having to reconfigure your computer. There are some serious buffer/timing issues in the new drivers! Offline #14 2007-06-26 19:07:00 somairotevoli Member Registered: 2006-05-23 Posts: 335 Re: X freezes (UNSOLVED) I have the same issues using kde w/ nvidia-71xx.

but i finally got pass the bsods and got it working again on 8 0 3cs2. You've read and tried everything. Loading... Check This Out The default settings are usually to name the session "Untitled" and save it somewhere in the C: drive.

i am using "openchrome" drivers rather than VIA of "xf86-video-via" and it has been 3 days, no single lockup except that audacious behaved very badly on one occasion only.you can find On OS X everything just runs fine but on Windows 7 it causes freezes. otobot11-05-2010, 09:10 AMThanks for replying spkguitar! but again, the solution is same as the #1.on Arch, this problems occur 3 times day and on Gentoo it occurs 2-3 times a week.

so obviously it was working before, i mean i know it doesnt match compatible charts perfectly but if it was working before, what made it stop working now? Please type your message and try again.            hwamil Level 1 (0 points) Q: firewire 800 crashes win 7 on bootcamp I am using a late 2011 15" MBP (8, Guess I have to try a firewire card before I can throw my hands up calling it a checkmate. While not included as part of the Security Center, antivirus software is another near-necessity for everyday computing.

Not sure if the target has to be on another drive since I image to a directory on my NAS. it's the same with the other dudes that have those issues. Click here for a printable PDF of this article Learn More About Microsoft Windows www.microsoft.com www.vistaultimate.com www.tweakvista.com www.tomshardware.com Contact PreSonus E-mail us any questions. Select Task Manager.