Home > Turn On > Computer Has Powe But Won't Boot

Computer Has Powe But Won't Boot

Contents

Do you have any suggestions? Electricity is not getting to the PC.Unplug the power cord. If the LED is on showing that power is reaching it, make sure your power button is properly connected and working. It was devastating. http://codecreview.com/turn-on/computer-won-t-boot-at-all-fans-turn-on-and-off.html

Thanks in advance. If not, try removing the RAM and see if your board beeps on power up. I opened up the tower and everything seemed fine, fan spinning, dvd drive open and closed but nothing else worked i.e usb mouse lit up neither did a usb keyboard. What I want to know is if it necessarily means that my cpu is broken or is it possible that the motherboard is broken which causes the cpu not to start. https://www.cnet.com/forums/discussions/computer-has-power-but-won-t-turn-on-367306/

Pc Wont Turn On No Power

Then after about 2 secs it beeps, 2 secs later it beeps again and keeps doing this until I turn it off. Perform these tests and inform me about the results. The only incompatibility I may imagine is that my old power supply has an ATX 20-pin power cord to the motherboard whereas the new motherboard has an ATX 24-pin connector. I can also run a disk called german police boot cd which loads fine & I get into the desktop only its XP pro on it.

To confirm it was defiantly the power supply I opened it up to find a blown capacitor.Thanks for your advice! wikiHow Contributor Take it to a computer repair specialist in case you are not comfortable doing it yourself. I don't have a hard drive connected to this machine so there were no others to check. My Computer Wont Turn On And Beeps Fortron, Enermax, Antec.

Reply to robinhoode robinhoodeJan 13, 2010, 12:01 AM Quote: Nah, I don't have one.. Pc Wont Turn On But Motherboard Light Is On I have made sure everything is plugged in, and tried plugging it into different outlets. If your solution fixes things, youve got my $20. This component changes the direct current (DC) coming from the battery or power supply to an alternating current required by the screen.

Report IRV- May 18, 2009 at 12:38 PM Thank you... Pc Not Turning On Motherboard Has Power If you can see the coloured wires inside the black outer protection, it could be time to buy a new PSU. Yes No Not Helpful 0 Helpful 0 Unanswered Questions When computer is not progressing past the Bios at startup. Then,nothing else.

Pc Wont Turn On But Motherboard Light Is On

With some basic troubleshooting, you can often solve boot up problems with your Windows or Mac computer. http://www.pcadvisor.co.uk/how-to/laptop/how-fix-pc-that-wont-boot-3528959/ I saw this on PC Advisor and thought you should see it too. Pc Wont Turn On No Power As soon as I plug it in the wall it powers on, and I have to unplug it to turn it off. Computer Has Power But Wont Turn On So it was giving me different problems: sometimes I could get into bios setup, sometimes just fans, sometimes no fans, sometimes windows would hang at the startup screen etc.

If your surge protector or power strip is under your desk, check to make sure a wandering toe didn't turn it off.If the cord appears to be fine and the socket I mean, the HDD's seemed to work, the CD/DVD worked, but I got no picture on the monitor and no sound (beep). Otherwise I don't see any reason why your system should not work. When I start my computer up I see the motherboard logo and then it attempts to boot up windows but its no good. Computer Wont Turn On At All

It goes through bootup sequence, looks like its going to boot up properly since everything lights up and disk drives work. Oh, and thank you for editing the thread title. I tried everything you posted and I haven't pinpointed the problem yet. Thanks for not being an ***** :giddy: Have you tried removing all but the necessary components and booting then?

Out of curiousity I google "no signal screen message . . ." to find questions and comments that match the problems I am having. Computer Won't Turn On Motherboard Light On Often it can be tricky to get a newly built PC to boot. Put them back in and no monitor shows, just the test screen that says it is working properly.

When you turn on the system with the memory card in, and after pushing the power button, if the system is working, you'll be able to turn on and off the

When I finished, I powered up the PC, all I am seeing now is the manufacturer's logo. but its just black. on your hdd will not work on with any other board. Computer Won't Boot Windows 10 This is to verify if the adaptor is giving proper voltage.

Tom's Hardware Around the World Tom's Hardware Around the World Denmark Norway Finland Russia France Turkey Germany UK Italy USA Subscribe to Tom's Hardware Search the site Ok About Tom's Hardware DJ Akshay or more appropriately Lord Akshay. The 2 memory cards I put back in are the 2 original ones! Is buying a POST card worth it for fixing one system?

I thought I had a motherboard issue similar to yours, no signs of life except fans. Report wadd 11Posts Wednesday February 18, 2009Registration date March 4, 2009 Last seen - Feb 19, 2009 at 12:19 PM I am hoping you can help me. Place your finger on the processor for 2 seconds. It will automatically shut down.

The best tip here is to disconnect everything except the bare minimum needed to boot to the BIOS: Motherboard CPU (with heatsink attached) Graphics card (if there's a graphics output on Flag Permalink This was helpful (0) Collapse - Found the problem... Aug 24, 2013 at 8:01 PM #23 xBruce88x Joined: Oct 29, 2009 Messages: 2,516 (0.95/day) Thanks Received: 757 System Specs System Name: Nightblade / Dell Latitude / Work Rig Processor: Core I had the same problem (no usb, monitor etc.).

A charger with a different voltage may not offer enough current to power your laptop. 3 Test it with a spare charger.