Or, at the very least, you'll be able to come into the shop with enough knowledge to avoid being played a fool. [Have a tech question? Troubleshooting a bad motherboard. take it out and clean with a rubber and kept it again. Ricardo Gardener 383,003 views 10:18 Computer Turns On But No Display - Led Light On Fan Spinning - CPU Stupid Mistake Easy Fix - Duration: 3:23. navigate here
Sign in to add this video to a playlist. Computer monitor help and support. Occasionally it still blanks out with 2 ram sticks installed causing me to have to rinse and repeat. if its okay then try to change all the data cables.
Published on 20 Aug 2014Heres the solution Category People & Blogs Licence Standard YouTube Licence Show more Show less Loading... After Windows loads (about 2 minutes after turning on the computer), press the power button briefly or press the Suspend key on the keyboard to see if the computer comes out Same problem. My Computer Turns On But Nothing On Screen screen is black. [Solved] (Solved) Can't exit power saving mode Computer will not load past welcome screen [Solved] (Solved) My computer wont go past the acer screen [Solved] (Solved) Helpful +413
Is there maybe a device that I might have to buy to find out or what? Cleared cmos with jumper on mobo. Is there any solution for it??? Check This Out These Hardware Installation Videos should come in handy as you're reinstalling your hardware. Test your computer's hardware using a Power On Self Test card.
thanks Report yousufmedia 2Posts Thursday October 15, 2009Registration date October 16, 2009 Last seen - Oct 16, 2009 at 09:27 AM please solve my problem all right but my computer not Computer Monitor Won't Turn On What should I do? Rebooted. Use the onboard video card if you have one...
Lee Helpful +16 Report rygetz Nov 22, 2009 at 11:38 AM I would start by checking every component. https://www.pugetsystems.com/help/troubleshooter.php?id=18 Get the answer rdc85Feb 25, 2013, 3:27 PM First unplug/disconnect all power source for all device (monitor, speaker, cpu, etc....)In the mobo there a silver coin like battery (CMOS battery), remove Pc Turns On But No Display Or Beeps what should I do? Computer Monitor No Signal Sep 28, 2010 #2 cloudyhawk TS Rookie Topic Starter Tried using the monitor on various working computers and all inputs (DVI, VGA, HDMI) and nope still nothing.
If the computer opens into a suspended state every time the computer is started, use the following steps to disable Power Savings in the BIOS. http://codecreview.com/turns-on/computer-turns-off-then-pressed-again-and-turns-on-fine.html frustrating finding an answer. Johnny Phung 1,968,409 views 11:59 PC WORKING BUT NO DISPLAY OR ANY BEEPS (UPDATE) - Duration: 2:02. Same problem. No Display On Monitor But Cpu Running
Any help please? Turned On, but same issue. 2). I did some research on Google about this issue & did a few things. 1). his comment is here The PSU tends to cause more problems than any other hardware and is often the cause of a computer not coming on all the way.Replace your power supply immediately if it
Reports: · Posted 6 years ago Top marks100 Posts: 4507 This post has been reported. Laptop Turns On But No Display Join the community here, it only takes a minute. The computer restarts.
After that I found the same problem then, I bring my PC to my office where the power is sufficient and it works. Actually when I turned on, it took a long time to get to display & then window was also working weird, then I restarted a couple of time & I though Try moving your mouse, clicking the mouse buttons, or pressing any key (e.g. Laptop Turns On But Screen Is Black We have used 3 seperate moniters, the hdd light does blink, and tapping f8 did nothing.
The purpose here is to remove as much hardware as possible while still maintaining your PC's ability to power on. If your computer starts normally with only essential hardware installed, proceed to Thanks and bestest Reply to ferniness Garry_6Jan 29, 2016, 7:00 AM my problem is the same. Report rich- May 11, 2011 at 07:18 PM i just got one of these at nickspcparts.com and it booted right up.... http://codecreview.com/turns-on/computer-turns-on-but-no-display-on-monitor-please-help.html Report edgar- Mar 26, 2010 at 10:36 PM mmmmm but I dont her no beep Report Hannan- Jul 19, 2010 at 04:51 AM I think it's power problem.
note: If you cannot select your monitor's native display resolution, then update the computer's video drivers and repeat this step. Give yourself room to grow. if all are working. as I think there is no POST screen, I wish your processor is not overheated.
Sign in to make your opinion count. Forget about the idea of preventative maintenance. I don't know what to do... Ask PCWorld Contributing Editor Lincoln Spector.
Reply to melvinmax10 rdc85Jan 5, 2015, 8:12 AM I got confused?is it solved or not? Swapped the processor for a lower speed processor. check all the particular pins of smps and read the voltage. Rebooted.